Clear-Com TEMPEST 2400 Spécifications télécharger pdf (Page 82)

Clear-Com Communication Systems Page 82 of 100

Tempest 2400 Wireless Intercom System

Call Function

Check to make sure that the CALL function is enabled.

Confirm that a TALK button is enabled for the channel that you wish to call.

A Call signal will be received by the beltstation only on the channel(s) that are currently being monitored.

Stage (SA) function does not work properly

The Stage button has two separate functions.

When you press the STAGE button it reroutes the beltstation user’s microphone to the SA output on the

back of the base station.

Optionally, it controls the shared Stage relay contact on the back of the base station.

When pressing the STAGE button, if there is no audio present at the SA, confirm that the Stage

Announce function is enabled in the beltstation.

If the SA relay does not close, ensure that the Stage Relay is enabled in the beltstation. If problems

persist, confirm the operation with another beltstation.

Tempest Remote Transceiver

Remote Transceiver RX or TX LEDs do not light

While the Transceiver is properly connected to the base station, turn the base station Power Switch to the

off position. Wait for 30 seconds and turn the base station Power Switch back to the ON position. This

should initialize the Remote Transceiver. The Config LED should light momentarily and then go out. Once

the Config LED goes out the Remote Transceiver TX LED should light. If there are beltstations

communicating to the base station through the Remote Transceiver the RX LED should light as well.

All digital, frequency hopping spread spectrum technology - no frequency coordination needed

2.4GHz offers World-Wide operation with no licensing requirements in most world-wide locations

2xTX

™

transmission voice data redundancy technology

Accu-Sync

™

timing system for improved performance with multiple base stations

iSelect

™

On-Command roaming

4 intercom channels and up to 5 full duplex beltstations per base station

Configure up to 10, 2.4GHZ base stations with 50 full duplex beltstations in a single system

Beltstations can access all 4 intercom channels and “Dual-Listen” to 2 of the 4 channels

Weather resistant beltstations

Beltstations can send and receive “Call Alert” signal from wired intercom systems

A beltstation CALL signal is sent only when the Talk button is enabled.

To manually re-initialize the Transceiver, power off the base station for at least 15 seconds and

power the base station back on, with the Transceiver connected.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 99 100

Pas de commentaire

Clear-Com TEMPEST 2400 Spécifications Page 82