Clear-Com TEMPEST 2400 Spécifications télécharger pdf (Page 78)

100

Clear-Com Communication Systems Page 78 of 100

Tempest 2400 Wireless Intercom System

Adjust Min/Max Beltstation Volume Levels

From the Beltstation:

To set the minimum volume, press MENU, select “Set Controls”, then “Volume Limit” and “Min

Volume”. Use the CH A/B knob to adjust the level and press ENTER to save the new setting.

To set the maximum volume, advance to “Volume Limit” as above, and then “Max Volume”. Use

the CH A/B knob to adjust the level and press ENTER to save the new setting.

From the Base Station:

Select the number key 1 through 5 that corresponds to the beltstation desired and select “Volume

Limit”.

To set the minimum volume setting, select “Min Volume”. Use the Volume/Scroll Knob to adjust

the level and press ENTER to save.

To set the maximum volume setting, select “Max Volume”. Use the Volume/Scroll Knob to adjust

the level and press ENTER to save.

Configure Stage Announce and SA Relay

From the Beltstation:

To set Stage Announce, press MENU; select “Set Controls;” select “Stage Announce;” select

“Momentary”. This is the default setting.

To set SA Relay, press MENU; select “Set Controls;” select “Stage Announce;” Select “SA Relay

Enable”. This is the default setting.

From the Base Station:

To set Stage Announce, select the numbered key 1 through 5 that corresponds to the beltstation

desired.

Select “Stage Announce;” select “Momentary”.

To set SA Relay, select the numbered key 1 through 5 that corresponds to the beltstation desired.

Select “Stage Announce;” select “SA Relay Enable”.

The STAGE button is always Momentary when enabled.

Configure Relays for Individual Beltstations

From the beltstation:

Press MENU; select “Set Controls;” select “Select Relay”. Note that there are more options under

“Set Controls” than fit on the screen. Scroll to the bottom of the screen and scroll one more detent

too see the “Select Relay” option. Select one of the relays: “Relay 1” thru “Relay 5”. When a relay

is selected a check mark will be visible beside the selection.

To activate the relay, a “Relay Button” must be selected. To select a “Relay Button”, one of the

relays must already have been selected.

To select a Relay Button: Press MENU; select “Set Controls;” select “Relay Button;” select one of

the button choices.

If Talk A/B or Talk C/D is selected to activate the relay, the relay will remain closed whenever the

button is selected for active talk.

If Ch A/B or Ch C/D is selected to activate the relay, the relay will remain closed whenever

channel B or D is selected.

If STAGE or ENTER is selected to activate the relay, the relay will remain closed whenever the

button is pressed, for as long as the button is held.

If STAGE is selected to activate the relay, and if Stage Announce Audio is enabled, and if the

Stage Announce Relay is enabled, all three functions will operate simultaneously.

If ENTER is selected to activate the relay, and if Wireless ISO is enabled, both functions will

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Clear-Com TEMPEST 2400 Spécifications Page 78

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte Clear-Com TEMPEST 2400