Clear-com Eclipse-PiCo Manuel d'utilisateur télécharger pdf (Page 26)

Clear-Com Communication Systems

Eclipse PiCo Matrix Instruction Manual

3-2

Scroll to a menu item by rotating the setup/enter knob. When the

desired menu item is highlighted on the screen, select it by pressing

the setup/enter knob.

Note: The PiCo display dims when the unit has not been used for

three minutes. Pressing any key causes the previously

displayed screen to reappear.

CHECKING PORT STATUS

Scrolling to and selecting Status on the Main menu causes the Status

menu to appear providing further options.

Figure 3-2: Status Menu

On scrolling to and selecting Ports on this menu the System Ports

menu appears, showing all of the available 36 ports graphically, with

their current status.

Figure 3-3: System Ports Menu

Each rectangle on the System Ports menu represents one of the 36

possible “port” connections in the system. A “port” connection is one of

the RJ-45 connectors on the PiCo’s rear panel to which remote panel

and interfaces are connected with shielded CAT-5 cable.

When a remote device is connected to a PiCo “port,” the rectangle will

first show a chequered pattern to indicate communications activity,

then will change to a solid light when the connected device is online

and communicating with the matrix.

In addition, a letter or number will appear above each rectangle to

indicate the type of connection, as follows:

STATUS MENU

GPO

PORTS

GPI

EXIT

SYSTEM PORTS

EXIT

“Source” refers to a

device—beltpack, intercom

panel, or a variety of other

devices—from which audio is

received.

“Destination” refers to a

device to which audio is sent.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 78 79

Pas de commentaire

Clear-com Eclipse-PiCo Manuel d'utilisateur Page 26