Clear-com Eclipse-PiCo Manuel d'utilisateur télécharger pdf (Page 16)

Clear-Com Communication Systems

Eclipse PiCo Matrix Instruction Manual

1-8

REMOTE INTERFACES

Interface modules convert the 4-wire signals of a central matrix port to

other types of signals that communicate with devices such as

telephones, camera intercoms, two-way radios, and so on. In this way

non-4-wire devices can communicate with the central matrix.

Each interface module has hardware connectors to connect to both the

central matrix and to the external device that communicates with the

central matrix. Most interface modules connect to the central matrix via

shielded category-5 cable terminated with RJ-45 connectors. The

DIG-2 digital interface module, however, connects to the central matrix

via double-shielded 24 AWG conductor category-6 enhanced

(CAT-6E) STP cable.

The type of cable used to connect the interface module to the

non-4-wire device varies with the device. Each of these connections is

described more fully in the individual manual for each interface.

The following interface modules are compatible with the Eclipse PiCo

matrix:

• TEL-14 telephone interface module

• CCI-22 dual party-line interface module

• FOR-22 four-wire interface module

• GPI-6 general purpose inputs interface module

• RLY-6 relay (general-purpose outputs) interface module

• AES-6 digital interface module

• DIG-2 digital interface module (transparent to the system,

configured in ECS as the type of panel it is connected to)

Each of these interfaces is described in its own manual. For a full

description of the operation, installation, and maintenance of an

interface, refer to the individual manual for that interface.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 78 79

Pas de commentaire

Clear-com Eclipse-PiCo Manuel d'utilisateur Page 16