Clear-com Eclipse-PiCo Manuel d'utilisateur télécharger pdf (Page 20)

Clear-Com Communication Systems

Eclipse PiCo Matrix Instruction Manual

2-4

SETUP/ENTER KNOB

The setup/enter knob is used in conjunction with the display window

(see above) to perform a variety of actions directly from the PiCo

matrix, without any need for the Eclipse Configuration System

programming software. See the chapter “Using the PiCo’s Front Panel

Display Menus” in this manual for more information.

DEFAULT IP ADDRESS

From Eclipse 4.2 release onwards a factory default IP address

(172.16.2.100) is set up in the matrix firmware which will always be

available via an IP reset. This ensures that once the matrix firmware is

loaded it will always be possible to access the matrix via ethernet even

if the current IP address is not known.

To carry out an IP reset it is necessary to remove the cover of the

Eclipse PiCo in order to access the three reset switches positioned at

the front left of the main circuit board (viewed from the front of the unit)

shown in Figure 2-2. To carry out an IP reset press and hold the

rightmost two switches (nearest the side of the case) simultaneously

and then press and release the ‘RESET’ button at the front of the unit,

then release the internal switches. The unit will then be reset to the

factory default IP address.

The unit cover should be replace immediately the operation is

completed.

Warning: As the unit must be powered when resetting the IP

address this operation should only be carried out by

qualified service personnel.

Figure 2-2: Eclipse PiCo Reset Buttons

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 78 79

Pas de commentaire

Clear-com Eclipse-PiCo Manuel d'utilisateur Page 20