Clear-Com HME DX210 Instructions d'exploitation télécharger pdf (Page 27)

Appendix B:

Multiple Base Station Daisy-Chaining

Two or more DX210 base stations can be “daisy-chained” together with cables connected to the 2-W

connectors on the rear panels of each base station, following Clear-Com

/ RTS

standards, or two base

stations (not more) can be “daisy-chained” together with cables connected to the 4-W or AUX connectors.

NOTE 1: DX210 does not provide 2-wire line power, therefore, 2-wire power bypass must be used.

RTS

Mode Clear-Com

Mode

Pin 1 = Common

Pin 2 = Channel 1

Pin 3 = Channel 2

Pin 1 = Common

Pin 2 = N/C

Pin 3 = Audio

NOTE 2: For AUX type daisy-chaining, the cable connectors must be 3-pin XLR.

 If using 4-wire connection, use cable with In/Out

crossed, as shown to the right.

(An Ethernet crossover cable will not work.)

IC In +  IC Out +

IC In –  IC Out –

IC Out +  IC In +

IC Out –  IC In –

 If using 2-Wire connections, open each base station and set jumpers JP1 (IC1) and/or JP2 (IC2) in

all base stations to ON for power detect bypass. Set jumpers JP5 (IC1) and/or JP6 (IC2) in only one

base station per channel for termination. Refer to Appendix C, page 22.

 Perform base station registration for each base station. Refer to Appendix D, page 23.

Clear-Com HME DX210 System Guide

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Pas de commentaire

Clear-Com HME DX210 Instructions d'exploitation Page 27